SynopsisRF Phase Shifters are used to change the transmission phase angle of an input signal. Ideally phase shifters provide an output signal with an equal amplitude to the input signal, any loss here will be accounted to the insertion loss of the component. The input.....
SynopsisRF over Fiber modules convert RF signals to optical signals and back. One unit has an optical transmitter which converts the signal from RF to Optical, and a second receiver unit converts the signal from Optical to RF. Both units are connected by the optical f.....
SynopsisA waveguide filter is an electronic filter that is constructed with waveguide technology. Waveguides are hollow metal tubes inside which an electromagnetic wave may be transmitted. Filters are devices used to allow signals at some frequencies to pass (the pass.....
SynopsisPhase Noise is a measure of the spectral purity of a signal in an oscillator system. It quantifies the short-term random variation of the frequency of the signal, and is a product of thermal noise and low frequency flicker noise injected into the oscillator.
SynopsisEMF measurements are measurements of ambient (surrounding) electromagnetic fields that are performed using particular sensors or probes, such as EMF meters. These probes can be generally considered as antennas although with different characteristics. In fact p.....
Synopsiswaveguide sliding short are low loss, non-contacting, movable shorts for use in a variety of microwave systems. They are valuable for establishing a reference impedance for the calibration and error analysis of waveguide measurement systems. The sliding shorts.....
SynopsisA horn antenna or microwave horn is an antenna that consists of a flaring metal waveguide shaped like a horn to direct radio waves in a beam. Horns are widely used as antennas at UHF and microwave frequencies, above 300 MHz. They are used as feed antennas (cal.....
SynopsisA phase-locked dielectric resonator oscillator (PLDRO) is a type of oscillator that is used in millimeter-wave communication systems, where phase noise performance is of utmost importance. As wireless communication systems are advancing, the system manufacture.....
SynopsisPE/PET Bicomponent fibers, also known as conjugate fibers, are composed of two different fiber-forming polymers or similar fiber-forming polymers of different properties. Since the two components contained in the fiber complement each other, the performance of.....
SynopsisES Fiber, also known as Electrostatically Spun Fiber or Electrospun Fiber, refers to a type of ultra-fine fiber made by electrospinning polymer solutions, used in various applications, including filtration, medical textiles, and wound dressings. The glob.....
